Want to buy or sell something? Check the classifieds
  • The Fedora Lounge is supported in part by commission earning affiliate links sitewide. Please support us by using them. You may learn more here.

Ebay Hats: Victories, Defeats, Gripes & Items of Interest

splintercellsz

I'll Lock Up
Messages
6,143
Location
Somewhere in Time
Than you, fellas!

I hope this one fits. It was measured to a 7, and I am a 7 1/8 - 7 1/4, but I may be able to squeeze into this one [huh] Alan, youi had a cap stretched, if I recall correctly?
 
Messages
15,089
Location
Buffalo, NY
I did and I've increased the circumference in a number of others from 6 7/8 up to my size. There are always risks and compromises with stretching but it can be a means to make a one of a kind headliner into a wearable cap.
 

rlk

I'll Lock Up
Messages
6,100
Location
Evanston, IL
Nice looking fabric. I have about 5-6 of this type--They tend to run smaller in the tucked flaps position than flaps down--a full size differential.

There are no stretchable materials inside and lots of seams and thin linings to tear. I've had minor separations putting them on my head and 3 were NOS to visual inspection. This would be like stretching your suit if it were short. Not like the typical separate sweatband and open weave fabric cap.

No reason to believe it predates the 20th Century.
 

rlk

I'll Lock Up
Messages
6,100
Location
Evanston, IL
I think this is a great comparison. I've been hunting for a suit stretcher on ebay with no success. I have a few suits that could use a little stretching around the middle.

Wrong direction--try Corsets and Girdles

Perhaps there's a Cranium Crusher
bs01.jpg
 
Last edited:

rlk

I'll Lock Up
Messages
6,100
Location
Evanston, IL
Probably, but they looked the same in 1900 as 1940.
I can squeeze on my 7-1/8 with flaps down(not even close at all retracted) so its likely it will be wearable at least in that configuration. They really are rather warm for temperatures other than when you want to cover your ears anyway.
 

jskeen

One of the Regulars
Messages
120
Location
Houston
Picked up a 100% fur beaver brand off feebay because the seller had several decent looking westerns listed dirt cheap, and I've been looking for some victims for my first attempts at diy drycleaning, conversion, stretching, blocking and resewing. Hoped I could add a couple more, as the shipping was more than the hats, but got outbid on all the rest.
http://www.ebay.com/itm/Vintage-Tan-Major-Beaver-Fur-Cowboy-Western-Hat-/200914341129?_trksid=p2047675.l2557&ssPageName=STRK%3AMEWNX%3AIT&nma=true&si=NQ5mhYjyuJrHkiLXLKSbkCiNBDU%253D&orig_cvip=true&rt=nc

Anyway, emailed him and he seemed like a nice guy, so I suggested a pig in a poke sale. I told him what I was wanting to do and what I was interested in, and said if you have something that might work, just hit me with an add on price. He came back with "I've got 3 fedora types that could use a little work, and I'll let you have them for $5 each on top of the one you have now. I figured "what the heck, that's less than a 12 pack of good beer, let's see what he's got. Total sale was $34.47 for 4 hats. I wasn't expecting a lot, but hey, I wasn't paying a lot either, and I did want some bodies that I wouldn't feel bad about messing with. So, box shows up today, and here's the take.

The primary, a "major" model beaver brand one size too small. It's pretty stiff and has a few small bugglies on it. Not too bad though.
CIMG0020.JPG

CIMG0019.JPG

A dirty but very solid Wormser with no scuffs or nibbles, with a nice soft sweat, and a working trolly, also 7 1/8 so will need a bit of a stretch.
CIMG0017.JPG

CIMG0018.JPG

A pretty badly chewed up Bradford in a 7 that I'm not sure I can do anything with, but might work for a kids costume piece.
CIMG0021.JPG

and this may be the pick of the litter, a nearly mint pilgrim, 7 3/8, clean, solid, un-nibbled and ready to tighten up a little and wear to the races.
2013-04-29

2013-04-29


Pretty happy with my new projects for $8.61 each. What do you guys think?
 
Last edited:

Rick Blaine

My Mail is Forwarded Here
Messages
3,958
Location
Saskatoon, SK CANADA
Picked up a 100% fur beaver brand off feebay because the seller had several decent looking westerns listed dirt cheap, and I've been looking for some victims for my first attempts at diy drycleaning, conversion, stretching, blocking and resewing. Hoped I could add a couple more, as the shipping was more than the hats, but got outbid on all the rest.
http://www.ebay.com/itm/Vintage-Tan-Major-Beaver-Fur-Cowboy-Western-Hat-/200914341129?_trksid=p2047675.l2557&ssPageName=STRK%3AMEWNX%3AIT&nma=true&si=NQ5mhYjyuJrHkiLXLKSbkCiNBDU%253D&orig_cvip=true&rt=nc

Anyway, emailed him and he seemed like a nice guy, so I suggested a pig in a poke sale. I told him what I was wanting to do and what I was interested in, and said if you have something that might work, just hit me with an add on price. He came back with "I've got 3 fedora types that could use a little work, and I'll let you have them for $5 each on top of the one you have now. I figured "what the heck, that's less than a 12 pack of good beer, let's see what he's got. Total sale was $34.47 for 4 hats. I wasn't expecting a lot, but hey, I wasn't paying a lot either, and I did want some bodies that I wouldn't feel bad about messing with. So, box shows up today, and here's the take.

The primary, a "major" model beaver brand one size too small. It's pretty stiff and has a few small bugglies on it. Not too bad though.
CIMG0020.JPG

CIMG0020.JPG

A dirty but very solid Wormser with no scuffs or nibbles, with a nice soft sweat, and a working trolly, also 7 1/8 so will need a bit of a stretch.
CIMG0017.JPG

CIMG0018.JPG

A pretty badly chewed up Bradford in a 7 that I'm not sure I can do anything with, but might work for a kids costume piece.
CIMG0021.JPG

and this may be the pick of the litter, a nearly mint pilgrim, 7 3/8, clean, solid, un-nibbled and ready to tighten up a little and wear to the races.
2013-04-29

2013-04-29


Pretty happy with my new projects for $8.61 each. What do you guys think?

Bloody well done! :thumb:
I anticipate the results with great excitement!

:gossip:...and lemme know if that Pilgrim ever needs a home.
 
Last edited:

Forum statistics

Threads
109,667
Messages
3,086,224
Members
54,480
Latest member
PISoftware
Top