suitedcboy
One Too Many
- Messages
- 1,348
- Location
- Fort Worth Texas or thereabouts
I think those are void of photos. I will explain as best I can: The leather sweatband can be made in a couple of basic ways. One is the non-reeded where the edge of the leather is directly sewn to the felt. The other is reeded where there is a vinyl tape folded in half longways with a plastic soild cord, called the reed, (think thick fishing line) captured in the fold. The reed is joined with a metal sleeve that is brass. The brass often oxidizes and turns green and bleeds through on vintage hats. The reeded tape is sewn to the leather sweatband and in turn the sweatband is folded inside out and the reeded tape is in turn sewn to the hat right at the break of brim to crown. I think a few reasons can be found for this. The reed style attachment lets the sweatband "float" so the sweatband can conform to your head with its irregularities better than when direct attached. The reed style stops some of the sweat and oils from bleeding into the felt so easily but doesn't stop it completely.
Visually there is a difference easily seen. The reed style has stitching on the edge of leather and then there will be a 1/8-3/16" edge outside of the leather. The edge can be rolled away from the felt at that spot easily to see the back of the leather sweatband stitiching.
Non-reed style will have the stitching holding the leather to the hat with no border and the leather can't be pulled away from the felt unless stitches are broken.
Visually there is a difference easily seen. The reed style has stitching on the edge of leather and then there will be a 1/8-3/16" edge outside of the leather. The edge can be rolled away from the felt at that spot easily to see the back of the leather sweatband stitiching.
Non-reed style will have the stitching holding the leather to the hat with no border and the leather can't be pulled away from the felt unless stitches are broken.