-
The Fedora Lounge is supported in part by commission earning affiliate links sitewide. Please support us by using them. You may learn more here.
front block?
- Thread starter Tom
- Start date
Featured products
-
Alden 403 Moc Toe Boot - Brown Chromexcel - $680 The classic "Indy" style Alden Boot in the classic Horween brown Chromexcel. -
Grant Stone Diesel Boot Dark Olive Chromexcel - #395 Goodyear welted, Horween Chromexcel, classic good looks. -
Himel Bros. - The Ross Mk. 1 Leather Jacket Classic D-pocket motorcycle/aviator style jacket.
Brad Bowers
I'll Lock Up
- Messages
- 4,187
Welcome to the Lounge, Tom.
I believe you're asking, specific to the #51 block, which is the front of the block, and which is the back? I had to figure that one out, too, since the #51 is higher on one end. I have only one #51 block, and I played with the hat that I blocked on it, and finally decided that the resulting hat looked best when the higher part of the block is at the back. This also makes the most sense, as the C-crown needs to be deeper at the back than the front.
Here is my #51 for illustrative purposes:
And a hat blocked with the low end to the front (Note, however, that this is not a C-Crown, but a diamond crease):
But, these are just my observations, and not based on what actual practice may be for the #51. Art, am I even close?
I say, low side in front, high side in back.
Conversely, using either end as the front might have advantages. For instance, if you use the high end as the front, you could get a sharper rake from front to back on the hat, with a shallower crease on top, which gives a different style than what I decided to use.
Brad
I believe you're asking, specific to the #51 block, which is the front of the block, and which is the back? I had to figure that one out, too, since the #51 is higher on one end. I have only one #51 block, and I played with the hat that I blocked on it, and finally decided that the resulting hat looked best when the higher part of the block is at the back. This also makes the most sense, as the C-crown needs to be deeper at the back than the front.
Here is my #51 for illustrative purposes:
And a hat blocked with the low end to the front (Note, however, that this is not a C-Crown, but a diamond crease):
But, these are just my observations, and not based on what actual practice may be for the #51. Art, am I even close?
I say, low side in front, high side in back.
Conversely, using either end as the front might have advantages. For instance, if you use the high end as the front, you could get a sharper rake from front to back on the hat, with a shallower crease on top, which gives a different style than what I decided to use.
Brad
