- Messages
- 16,842
No Aero CR that I've handled flared at the bottom.
Do both the CR and BR flare slightly out at the bottom of the jacket? It appears that it's most prominent when the jacket is unzipped. If so is the flare about equal on both jackets? Thanks.
The Aero Cafe' Racer and the Aero Board Racer are both very straight...with little to no flare at the bottom of the jacket. If you're looking to wear the jacket open quite often, you'll be happiest with the Board Racer!
Wait, but the zipper on BR stops a good few inches above the bottom hem, right? That would perhaps make the jacket look like it's got a flare.
I like them flared... View attachment 48358 View attachment 48359
I like them flared... View attachment 48358 View attachment 48359
I think you need to go down a size or two.
I suspect the shoulder measurement is the critical factor with a Board Racer pattern, making a fit jacket all the more relevant. Thie is particularly illustrated by @pawineguy's earlier post #10 illustrating that the shoulder measurement of the size 44 Board Racer is still smaller even when sizing up from a size 42 Sheene/Cafe Racer pattern:
42 Sheene (Cafe Racer) = 23.5" pit to pit and 19.5" shoulder
44 Board Racer = 23.5" pit to pit and 18.75" shoulder
@pawineguy has probably given us more raw information regarding sizing of Aero jackets than any other single Lounge member.
Really? One size smaller and i will not be able to move. Two size down i will be buried in the jacket after death by suffocation.